NA Map Light Installation Document

Removal of the factory NA6 OEM map lights

1. Unscrew and remove the glovebox, and steering column shield to gain more working room.

2. Unplug the original map light from the harness, and pop it out. The map light is held on by a clip on either side.

3. Do the same for the driver’s side factory map light.

Removal of the factory NA8 OEM map light

1. Unscrew glove box to gain more working room.

2. Unplug the original map light from the harness, and pop it out. The map light is held on by a clip on either side.

Installation of the RM Map Light upgrade kit

1. Taking the back mounting bezel assembly (this is the panel with the LED, and various toggle[s]), place it behind the dash, and plug it into the factory harness (this is where removing the glovebox is crucial towards ease of access).

2. Position the back mounting bezel on the backside of the dash where the original map light opening is located. Note: This bezel should be located behind the dash.

3. Place the front bezel into the recessed hole where the original map light used to reside.

4. Line up the 4 mounting corner holes and insert a provided M3 machined screw into each hole.

5. Hand tighten until it is snug. It should not be any more than 2-3 ft lbs at most.

WARNING: DO NOT OVER-TORQUE THE SCREWS!!

STRIPPED THREADS ARE NOT COVERED UNDER WARRANTY.